Publicité
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other
end.
DMX connector configuration
Caution: Do not allow contact between the ground and the fixture's chassis ground. Grounding
the ground can cause a ground loop, and your fixture may perform erratically. Test cables with an
ohm meter to verify positive pole and to make sure the pins are not grounded or shorted to the
shield or each other.
3-PIN TO 5-PIN CONVERSION CHART
Note: If you use a controller with a 5 pin DMX output connector, you need to use a 5 pin to 3 pin
adapter.
The chart below details a proper cable conversion:
Publicité
