Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cutting depth adjustment
Overload Protection
In order to protect the user, the motor and the tool, the ESS 1300 is
equipped with an electronic and thermal overload protection.
Electronic:
In case of overload caused by a grinding pressure
which is too high, the
speed of the machine. You can continue working when the
grinding pressure has been reduced.
Thermal:
By means of a thermal sensor, in case of continuous
overload, the motor is protected against destruction.
fact, the machine switches off automatically and only can
be switched on again after a certain cooling period (about 2
minutes).
depends on the heating of motor winding and ambient
temperature.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
The cutting depth can be adjusted from 0 to 40
mm. Loosen the toggle screw and with the
help of the depth stop, set the required cutting
depth to match the thickness of the work piece
to be cut.
Then tighten the screws again.
After completing the work, set the depth stop
to zero to prevent the blade guard from being
accidentally pushed back. Risk of injury!
electronics react by decreasing the
Press the on/off switch. The cooling period
19
In
Publicité
Table des Matières
