EIBENSTOCK ESS 1300 Notice Originale page 18

To dismantle, loosen the 4 Allen
screws with the Allen key
supplied and remove the saw
blade from the spindle. To do so,
it may be necessary to heat the
screws, since they are fastened
with Loctite (e.g. use a heat gun).
In order to check whether the spindle stop is released before you
switch on the tool, turn the spindle slightly.
Then fit the floor guard.
Use only original Eibenstock-accessory!
Let the machine run for a short period of time and in a safe position. If
the machine does not run easily, stop working immediately.
Switch the device on and insert carefully into the material to be cut. When
cutting in the material, always guide the saw to the right. Hold the device
tightly in both hands.
Cutting height adjustment
Fit the saw on the spindle by reversing
the sequence. Make sure that the
holes in the saw blade point upwards!
To make it easier to change the blade,
use the spindle lock to clamp it.
The cutting height can be adjusted from
1.5 to 30 mm.
Loosen the two knurled screws on the right
and left of the guide rollers and set the
required cutting height with the help of the
scale. Then tighten both screws again.
Before starting work, check the cutting
height on a test piece.
18