Troubleshooting - Parkside Performance Ppstda 20-Li A1 Traduction Des Instructions D'origine

GB MT
and 45 °C. Avoid extreme cold
or heat during storage to ensure
the battery output is not adversely
affected.

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Device works with inter-
ruptions
Poor sawing performance
Saw blade quickly be-
comes blunt
40
• Remove the battery from the
device before storage over a longer
period (see separate operating in-
structions for battery and charger).
Possible cause
Rechargeable battery (29)
not inserted
On/Off switch (8) is
broken
Rechargeable battery (29)
discharged
Defective motor
Internal loose contact
On/Off switch (8) is
broken
Saw blade (25/26) unsuit-
able for the workpiece to
be processed
Saw blade (25/26) blunt
Low battery power
Incorrect sawing speed
Saw blade (25/26) unsuit-
able for the workpiece to
be processed
Too much pressure ap-
plied
Sawing speed too high
Error correction
Inserting the battery,
p. 38
Contact the service
centre.
Charge the battery (see
the separate operating
instructions for the re-
chargeable battery and
charger)
Contact the service
centre.
Contact the service
centre.
Contact the service
centre.
Use a suitable saw blade
(25/26)
Use a new saw blade (25/
26)
Charge the battery (see
the separate operating
instructions for the re-
chargeable battery and
charger)
Adjust sawing speed
Use a suitable saw blade
(25/26)
Reduce the pressure
Reduce the sawing speed