Würth SEG 10 COMPACT Traduction Des Instructions De Service D'origine page 16

Heavily soiling or stains
1. Apply cleaning solution with the suction turbine
switched off and let it work for 10 to 15 min-
utes.
2. Clean the area as with normal soiling.
Upholstery cleaning
1. Use less detergent for sensitive fabrics and
spray the surface at a distance of approx. 200
mm. Then only vacuum.
Cleaning tips
 Spray heavily soiled areas in advance and al-
low the cleaning solution to work for 5 to 10
minutes.
 Always work from light to shadow (from win-
dow to door).
 Always work from the cleaned to the uncleaned
area.
 The more sensitive the covering (oriental bridg-
es, Berber, upholstery fabric) the lower the con-
centration of detergent.
 Carpets with jute backs can shrink and bleed in
colour if the work is too wet.
 Brush wet pile carpets in the direction of the pile
after cleaning when wet (e.g. with a fibre brush
or scrubber).
 Impregnating after wet cleaning prevents the
textile from being quickly soiled again.
 To avoid pressure points or rust stains, do not
walk on or furnish the cleaned area until after it
has fully dried.
 To improve the cleaning result, rinse the object
with clean water after using detergents.
Detergent
Carpet and upholstery
cleaning
For further information, please request the product
information sheet and the EU safety data sheet for
the relevant cleaning agent.
16
R1 cleaner
BMF cleaner
English
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device dur-
ing transport.
1. Wind the mains cable around the carrying han-
dle of the device and the cover. Place the
spray/suction hose in the hook. Insert the up-
holstery nozzle into the accessory holder.
Illustration D
2. When transporting the device in vehicles, se-
cure it to prevent it from slipping or overturning
in accordance with the respective valid guide-
lines.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device dur-
ing storage.
The device may only be operated indoors.
Care and maintenance
DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
ATTENTION
Clogged ventilation slits
Risk of damage to the suction turbine
and the spray pump
Keep the device and ventilation slits
clean to ensure good and safe working
conditions.
 Should the spray retraction device fail in spite
of our thorough manufacturing and testing pro-
cedures, have the repair performed by a Würth
Master Service.
In Germany you can contact Würth Master Ser-
vice free of charge on 0800-WMASTER
(0800-9 62 78 37) or in Austria on 0800-20
30 13.