Würth SEG 10 COMPACT Traduction Des Instructions De Service D'origine page 15

Operation
Switching on the device
1. Connect the mains plug.
2. Press the suction switch to switch on the suction
turbine.
3. Press the spray switch to switch on the spray
pump.
Cleaning mode
ATTENTION
Danger from cleaning solution
Risk of damage
Before using the device, check the object
to be cleaned for colour fastness and wa-
ter resistance in an inconspicuous place.
1. Remove loose dirt from the object to be
cleaned.
2. Press the lever on the handle to spray the clean-
ing solution.
3. Run over the surface to be cleaned in overlap-
ping paths. Pull the nozzle backwards (do not
push).
4. When changing the nozzle, the upholstery noz-
zle can be inserted into the holder for accesso-
ries.
Switching off the device
1. Switch off the spray switch and the suction
switch.
2. Pull out the mains plug.
Empty the wastewater container
1. Switch off the suction switch and the spray
switch when the wastewater container is full.
2. Remove the cover.
3. Remove the wastewater container from the de-
vice and empty it.
Emptying the fresh water tank
1. Switch off the device.
2. Briefly operate the lever on the handle to re-
lieve pressure.
3. Disconnect the handle from the spray/suction
hose.
4. Hang the suction hose in the fresh water tank.
5. Press the suction switch to switch on the suction
turbine.
6. Suck the fresh water tank empty and switch off
the device.
7. Remove the cover.
8. Remove the wastewater container from the de-
vice and empty it.
Flushing the device
1. Connect the handle (with upholstery nozzle) to
the suction hose.
2. Connect the spray hose coupling to the handle
and latch into place.
3. Pour approximately 2 litres of tap water into the
fresh water tank. Do not add detergents.
4. Press the spray switch to switch on the spray
pump.
5. Hold the upholstery nozzle over a drain.
6. Operate the lever on the handle and flush the
device for 1 to 2 minutes.
7. Switch off the device.
Each time after use
1. Flush the device.
2. Drain the wastewater container and clean it un-
der running water.
3. Empty the fresh water tank.
4. Clean the exterior of the device with a damp
cloth.
5. To avoid unpleasant smells, remove all water
from the device before long downtimes.
6. Let the device dry thoroughly: Remove the cov-
er or move it to the side.
Storing the device
1. Wind the mains cable around the carrying han-
dle of the device and the cover.
Illustration C
2. Store the device in a dry room and secure it
against unauthorised use.
Cleaning methods
Normal soiling
1. Spray and vacuum up the cleaning solution in
one step.
Note
Repeated vacuuming without spraying shortens
the drying time.
English 15