Fitting And Adjusting The Carrying System - Stihl KMA 130 R Notice D'emploi

English
1 2
5
6
► If the connecting cable is fitted through the upper left
opening (1) or the upper right opening (2):
► Open the press studs (5).
► Lay the connecting cable over the shoulder strap (6).
► Close the press studs (5).
► If the connecting cable is fitted through the lower left
opening (3) or the lower right opening (4): Seal the
opening you use (3 or 4) with the hook and loop fastener
(7).
► Arrange the connecting cable so that it is as short as
possible without hindering your work.
7.2.2

Fitting and Adjusting the Carrying System

► Put the battery on your back.
► Close buckle (2) on the waist belt.
► Close buckle (1) on the chest strap.
38
3
4
7
1
► Tighten the straps until the waist belt fits snugly on your
hips and the back padding is against your back.
► Thread the end of the waist belt through the loop (3).
► Fit the hip pad as described in the instructions supplied
with the hip pad.
2
► Adjust the strap (1) so that the carabiner (2) is about a
hand's width below your right hip.
7 Adjusting KombiMotor for User
3
1
0458-805-9621-A