English
7.3.3
Fitting and Adjusting the Carrying System
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the carabiner (2) is
about a hand's width below your right hip.
7.4
Adjusting the Loop Handle
The loop handle can be set to different positions to suit the
height and reach of the user.
► Switch off the KombiMotor and pull the connecting cable
plug out of the socket.
► Loosen the screws (2).
► Move the loop handle (1) to the required position and
make sure that:
– The spacer sleeve (3) fits between the loop handle (1)
and carrying ring.
– 'a' = no more than 25 cm.
40
1
2
a
1
2
3
8 Inserting and Removing Connecting Cable Plug
► Tighten down the screws (2) so that the loop handle
cannot be rotated on the drive tube.
8 Inserting and Removing Connecting
Cable Plug
8.1
Inserting the Connecting Cable Plug
► Hold connecting cable plug (2) so that the arrow on its side
lines up with the arrow on the socket (1).
► Insert the connecting cable plug (2) in the socket (1).
The plug (2) engages in position.
8.2
Removing the Connecting Cable Plug
► Grip the connecting cable plug (2) with your hand.
► Pull the plug (2) out of the socket (1).
1
2
1
2
0458-805-9621-A