Johnson AURUM R290 M Serie Guide D'utilisation page 91

Mounting on a wall (with an 86-type box)
Install the back cover on an 86-type box with two M 4 x 25 screws, and fixing the box on the wall with two ST 4 x 20
screws. If the box is not embedded in the wall completely, you could save two ST 4 x 20 screws depending on the
situation.
Adjust the length of the plastic bolt in the accessory box to make it suitable for installation.
Fix the wired controller's bottom cover to the wall through the screw bar by using cross head screws. Make sure
the bottom cover is set flush on the wall.
Electrician
box
Buckle the front cover, and fit the front cover to the back cover properly, leaving the wire unclamped during the
installation.
To prevent water from entering the remote wired controller, use traps and plugs to seal the wire connections
during wiring.
Signal switching
wire
Screw hole on the wall; Use two ST 4 x 20 mm screws
Signal switching wire
Screw hole on 86 electrical box; Use two M 4 x 25 mm screws
Sensor cannot be
affected with damp
NOTE
34
V.1