Publicité
EN
-
With the equipment switched off and disconnected from the power supply, connect all audio sources to
the inputs and the amplifiers/mixers/amplifiers to the outputs.
-
Connect the rest of the optional modules to the same local network.
-
Once the connections are made according to your needs, connect the system to the mains and turn it on.
-
Use the software to configure: the mix of each output signal, the volume on the inputs and outputs, the
DSP settings, the GPIO ports, etc.
-
After use, do not forget to switch it off and disconnect it from the mains.
RESTRICTIONS OF AN INSTALLATION
There is no limit to the number of NMXmatrices, NMX-WP panels or TAB-10-16 displays installed in an
-
installation.
-
Each matrix can have up to 20 NMX-WPassociated with it.
Each matrix can be controlled from multiple TAB-10-16, displays, Android tablets or iPads without
-
quantity restrictions. Recomendado hasta 20 pantallas.
- The PC software can control up to 8 matrices simultaneously.
WIRING
DATA CABLES (LAN, LAN+PoE and Dante)
All devices communicates via data networks and therefore its communication cabling is straightforward.
Use data cables of at least category 5e or 6. Any connection made via Ethernet network cable and data
cable is restricted to a maximum length of 100 metres. These cables with RJ45 connectors at both ends and
straight (PINOUT T-568B at both ends):
A CONNECTOR
RJ-45(T-568B)
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Please note that both the MCMD-2 microphones and the TAB-10-16 touch screens are powered through
the data cable itself, so it is recommended to use Cat.6 or higher cables.
the maximum length of these cables will depend on the router or switch equipment used and
IMPORTANT:
the quality of the cables. Under optimal conditions, the length of the cables should not exceed 100 m.
ANALOGUE INPUTS AND OUTPUTS OF THE MATRIX
Use suitable and not excessively long cables for connections: Shielded cables, preferably low capacity.
CABLE
B CONNECTOR
STRAIGHT
RJ-45(T-568B)
White-Orange
Orange
White-Green
Blue
White-Blue
Green
White-Brown
Brown
PIN
Balanced Signal
Ground
-
Audio signal -
+
Audio signal +
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Unbalanced Signal
Ground
Ground
Audio signal
- 6 -
PIN8
PIN1
Publicité
