Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents / Inhalt / Contenu / Contenido
Contents
Page -17
3. Signs, symbols and abbreviations
7.
Inhalt
Seite 18-1
7.
2 WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio HP-1/HP-2
GB
D
GB
Contenu
Page 2-46
7.
Contenido
Paginás 46-60
D
4. Función
7.
E
F
1. Important details for your information
1. Important details for your information
F
Read these operating instructions before installing and starting the pressure transmitter. Keep
the operating instructions in a place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care
but it is not feasible to take all possible applications into consideration. These installation and
operation instructions should meet the needs of most pressure measurement applications. If
questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.wika.de / www.wika.com
The product data sheet is designated as PE 81.29 (HP-1) / PE 81.53 (HP-2)
Contact WIKA for additional technical support (+49) 9372 / 132-295
With special model number, e.g. HP-20000, please note specifications in the delivery note.
If the serial number on the product label and/or the 2D code on the hexagon gets illegible (e.g.
by mechanical damage or repainting), the retraceability of the instrument is not possible any more.
WIKA pressure transmitters are carefully designed and manufactured using state-of-the-art
technology. Every component undergoes strict quality and environmental inspection before
assembly and each instrument is fully tested prior to shipment. Our environmental manage-
E
ment system is certified to DIN EN ISO 14001.
As the highly pressurised materials are subject to extreme loads a permanent load cycle stabi-
lity is only given to a limited extent. This applies in particular to dynamic applications. Accor-
ding to this the pressurised parts of the HP-1 / HP-2 are wear parts which are not included in
the warranty.
Use of the product in accordance with the intended use HP-1/HP-2:
Use the pressure transmitter to transform the pressure into an electrical signal in extremly
high pressure applications > 1000 bar.
Knowledge required: Install and start the pressure transmitter only if you are familiar with the
relevant regulations and directives of your country and if you have the qualification required.
You have to be acquainted with the rules and regulations on measurement and control tech-
nology and electric circuits, since this pressure transmitter is „electrical equipment" as defined
by EN 50178. Depending on the operating conditions of your application you have to have the
corresponding knowledge, e.g. of aggressive media or high pressures.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio HP-1/HP-2
GB
Publicité
Table des Matières
