Intended Use; Personnel Qualification - WIKA HP-2 Mode D'emploi

2. Safety
WARNING!
■
■
EN
■
Further important safety instructions can be found in the individual chapters
of these operating instructions.
2.1

Intended use

The pressure sensor is used to convert pressure into an electrical signal.
The instrument has been designed and built solely for the intended use described here,
and may only be used accordingly.
The technical specifications contained in these operating instructions must be
observed. Improper handling or operation of the instrument outside of its techni-
cal specifications requires the instrument to be taken out of service immediately and
inspected by an authorised WIKA service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary
to the intended use.
2.2 Personnel qualification
WARNING!
Risk of injury should qualification be insufficient!
Improper handling can result in considerable injury and damage to equipment.
The activities described in these operating instructions may only be carried
out by skilled personnel who have the qualifications described below.
Skilled personnel
Skilled personnel are understood to be personnel who, based on their technical training,
knowledge of measurement and control technology and on their experience and knowl-
edge of country-specific regulations, current standards and directives, are capable of
carrying out the work described and independently recognising potential hazards.
Special operating conditions require further appropriate knowledge, e.g. of aggressive
media.
6
Open the connections only after the system has been depressurised.
Observe the working conditions in accordance with chapter 3 "Specifica-
tions".
Always operate the pressure sensor within the overpressure limit.
WIKA operating instructions pressure sensor, model HP-2