Safety; Intended Use - WIKA TF40 Mode D'emploi

1. General information / 2. Safety
DANGER!
... identifies hazards caused by electric power. Should the safety instructions not be
observed, there is a risk of serious or fatal injury.
WARNING!
... indicates a potentially dangerous situation that can result in burns, caused by hot
surfaces or liquids, if not avoided.

2. Safety

WARNING!
Before installation, commissioning and operation, ensure that the appropriate
temperature sensor has been selected in terms of design and specific measuring
conditions.
Non-observance can result in serious injury and/or damage to the equipment.
Further important safety instructions can be found in the individual chapters of these
operating instructions.

2.1 Intended use

The model TF40 duct temperature sensor is used for temperature measurement in heating,
ventilation and air-conditioning technology. It is primarily used in air ducts.
The instrument has been designed and built solely for the intended use described here, and may
only be used accordingly.
The technical specifications contained in these operating instructions must be observed.
Improper handling or operation of the instrument outside of its technical specifications requires
the instrument to be taken out of service immediately and inspected by an authorised WIKA
service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the
intended use.
WIKA operating instructions model TF40
GB
5