Publicité
1- Symbols and their meaning
2- General safety warnings
GENERAL POWER TOOLS SAFETY INSTRUCTIONS
SPECIAL SAFETY RULES
-
When drilling into walls, make sure you do not cut power lines and gas or water pipes. If in
doubt, use a metal detector.
-
Always unplug the drill before changing the drill bit or bit.
-
The chuck key should always be stored in the key holder.
-
Secure firmly the workpiece with a clamping device to avoid injury.
-
When drilling or screwing: Do not allow the engine to stall under load.
-
In the event of an electrical or mechanical fault, unplug immediately and remove the plug
from the socket.
CAUTION – TO REDUCE RISK OF INJURY, USER MUST READ INSTRUCTION
MANUAL
GENERAL SAFETY RULES FOR POWER TOOL
WARNING Read all safety warnings, instructions, illustrations and specifications
provided with this power tool. Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE
ORIGINAL INSTRUCTIONS
Read instructions and user manual carefully
Product complies with safety requirements and European Directives
Class II device – Double Insulation
Risk of damage or injury in case of non-compliance with the instructions
in this manual
Immediately disconnect the plug from the power outlet if it is damaged,
and for all maintenance operations.
Always wear protective goggles
Always wear ear protectors
Always wear a protective mask
Always wear gloves
19
Publicité
