Table des Matières
Publicité
1
1
1
2
3
3
2
1
Presser Foot Lever and Additional Presser
Foot Clearance
1
Use this lever
to raise and lower the presser foot.
When the presser foot is raised, tension discs are open.
When the presser foot is lowered, tension discs are
closed and sewing can begin.
You can raise the presser foot about 6mm (1/4") higher
than the normal up position for easy removal of the
presser foot or to place heavy fabrics under the presser
foot. Pull the presser foot lever up beyond the normal up
position.
How to Snap Presser Foot Off and On
To snap off:
Hand turn the flywheel toward you to raise the needle.
OR Press the Up/Down Needle key until the needle is in
an up position (Model 3230 only).
Raise the presser foot.
Press the presser foot release lever
will drop off.
To snap on:
Place the presser foot so that the pin
just under the groove of the shank
to attach the foot.
How to Remove and Attach the Shank
Raise the presser foot.
1
Turn the setscrew
screwdriver to remove the shank.
When attaching, align hole in shank
3
presser bar
and insert setscrew. Turn setscrew
clockwise to tighten.
16
1
. The presser foot
2
on the foot lies
3
. Lower the shank
counterclockwise with the
2
with hole in
Publicité
Table des Matières
