Wiring Remote Temperature Sensor - EcoNet RETST700SYS Guide D'utilisation

Wiring Remote Temperature Sensor

The EcoNet Smart Thermostat is optimized to work with the Aprilaire 8051 Temperature Sensor (10K thermistor).
Use the S1 and S2 terminals on the wall plate terminal block. Only one remote temperature sensor can
be supported.
Installer Checkout Basic Settings Basic Settings
68 80 80 80
Backlight Enabled?
Yes
Set Point Deadband 2º F
Zoning System Test Linearize Dampers
Resume Schedule Group 1 Away
71 71 72 75 36
Outside Temp Selection? T957_O Low Refrigerant Pressure
Internet
Temperature Offset 0.0º F
Relative Humidity Offset 0.0 %
Room Sensor Selection Internal
Home Away
status: Setting airflow
Proximity Sensing? No
Refrigeration Cooling to
Smooth Arrival Enabled? No
70 34 85 65
OFF
BACK BACK BACK
The following table shows the correct resistance at various ambient temperatures without the sensor wires
attached to the thermostat.
Temperature (°F)
30
40
50
60
70
80
90
100
> Return to Table of Contents
Menu > Settings > Basic > Room Sensor Selection
Zone 3
Zone 4
!
You can choose to have the system function based on the temperatures
21
measured by the internal sensor of the thermostat, the remote sensor or the
61% 47% 44% 44%
average between the two sensors.
CFM: 840
54
Dining Room MORE
Basement UNITS
Resistance (kΩ)
34.6
26.1
19.9
15.3
11.9
9.4
7.4
5.9
EcoNet Smart Thermostat User Guide
®
27