Parkside 465674 2404 Instructions D'utilisation Et Consignes De Sécurité page 17

The LCD display
dimensions.
After measurement:
After carrying out the measurement, move
the external measuring jaws
measuring jaws
turning the handwheel
clockwise.
Switch the LCD display
pressing the ON / OFF key
Tip: The LCD display
switches itself off after approx. 5 minutes.
Tighten the locking screw
turning it clockwise until you feel some
resistance.
˜ Examples of use
Tip: When measuring, always proceed as
described in the chapter on using the caliper.
Comparison of plug and socket
(see Fig. C):
First measure the dimensions of the plug
(see Fig. C.1).
You may wish to make a note of the
measurement.
Then, measure the socket (see Fig. C.2).
Deviation from a reference value
(see Fig. D):
Measure a reference object (in this case
A) (see Fig. D.1).
Leave the measuring jaws
position and press the key to obtain the
zero setting (ZERO)
Then measure the second object
(see Fig. D.2). The LCD display
shows the deviation of the measurement
of the second object to that of the
reference object (A).
Measuring the thickness of the floor of an
object (see Fig. E):
First measure the depth of the object
(see Fig. E.1).
Leave the depth blade
and press the key to obtain the zero
position (ZERO)
Now measure the entire object
(see Fig. E.2). The LCD display
shows the thickness of the floor of the
object.
16 GB/IE/NI
now displays the
5 ] [
together again by
2 ] [
inwards
7 ] [
[ 5 ]
automatically
5 ] [
.
[ 9 ]
in this position
6 ] [
.
[ 9 ]
/ internal
11 ] [
off again by
.
10 ] [
again by
4 ] [
/ in this
[ 2 ] 11 ] [
now
5 ] [
now
5 ] [