VEVOR WB25101 Mode D'emploi page 6

Assembly
1)
Locate the Spigot from the worm bin
which comes with two pieces of plastic
washers and one piece of plastic nut；
2)
Place one piece of the plastic
washers inside the recess in front of the
Base,then,insert the Spigot through the
hole；
3)
Insert the other piece of plastic
washer through the threaded part from
the inside of the Base, and then, screw
the plastic nut onto the thread, and
hand -tighten the nut;(Caution! Make
sure the plastic nut is tightened enough
to prevent leakage);
5