Playback; Playing A Disc; Playing An Ipod/Usb Device; Operating An Ipod Directly - Passenger Control - Sony XSP-N1BT Mode D'emploi

Playback

Playing a Disc

1
Insert the disc (label side up).
Playback starts automatically.

Playing an iPod/USB Device

In these Operating Instructions, "iPod" is used as a
general reference for the iPod functions on an iPod
and iPhone, unless otherwise specified by the text
or illustrations.
For details on the compatibility of your iPod, see
"About iPod" (page 20) or visit the support site on
the back page.
MSC (Mass Storage Class)-type USB devices (such as
a USB flash drive, digital media player, Android
phone) compliant with the USB standard can be
used.
Depending on the digital media player or Android
phone, setting the USB connection mode to MSC is
required.
Notes
 For details on the compatibility of your USB device,
visit the support site on the back page.
 Playback of the following MP3/WMA/WAV files is not
supported.
 lossless compression files
 copyright-protected files
 DRM (Digital Rights Management) files
 Multi-channel audio files
1
Connect an iPod/USB device to the USB
port (page 7).
Playback starts.
If a device is already connected, to start
playback, press SOURCE to select [USB] ([IPD]
appears in the display when the iPod is
recognized).
2
Adjust the volume on this unit.
To stop playback
Press OFF.
12
GB
To remove the device
Stop playback, then remove the device.
Caution for iPhone
When you connect an iPhone via USB, phone call
volume is controlled by the iPhone, not the unit. Do
not inadvertently increase the volume on the unit
during a call, as sudden loud sound may result
when the call ends.
Operating an iPod directly (Passenger
control)
Press and hold MODE during playback until [MODE
IPOD] appears to enable operation by the iPod
directly.
Note that the volume can be adjusted only by the
unit.
To exit passenger control
Press and hold MODE until [MODE AUDIO] appears.

Playing a BLUETOOTH Device

You can play contents on a connected device that
supports BLUETOOTH A2DP (Advanced Audio
Distribution Profile).
1
Make BLUETOOTH connection with the
audio device (page 7).
2
Press SOURCE to select [BT AUDIO].
3
Operate the audio device to start
playback.
4
Adjust the volume on this unit.
Notes
 Depending on the audio device, information such as
title, track number/time and playback status may not
be displayed on this unit.
 Even if the source is changed on this unit, playback of
the audio device does not stop.
 [BT AUDIO] does not appear in the display while
running the "App Remote" application via the
BLUETOOTH function.
To match the volume level of the BLUETOOTH
device to other sources
Start playback of the BLUETOOTH audio device at a
moderate volume, and set your usual listening
volume on the unit.
Press SOUND, then / to select [BTA VOL]
(page 18).