Usb Playback; Bluetooth Function - Sony MEX-BT4100P Mode D'emploi

USB playback

You cannot play back items via a USB hub.
 This unit cannot recognize USB devices via a
USB hub.
Cannot play back items.
 A USB device does not work.
– Connect it again.
A USB device takes longer to play back.
 The USB device contains files with a
complicated tree structure.
The sound is intermittent.
 The sound may be intermittent at a high-bit-
rate of more than 320 kbps.
Pandora® connection is not possible.
 Shut down Pandora® application on the mobile
device, and then launch again.
Application name is mismatched with the
actual application in App Remote.
 Launch the application again from the "App
Remote" application.

Bluetooth function

The connecting device cannot detect this
unit.
 Before the pairing is made, set this unit to
pairing standby mode.
 While connected to a Bluetooth device, this
unit cannot be detected from another device.
– Disconnect the current connection and
search for this unit from another device.
 When the device pairing is made, set the
Bluetooth signal output to on (page 23, 24, 25).
Connection is not possible.
 The connection is controlled from one side
(this unit or Bluetooth device), but not both.
– Connect to this unit from a Bluetooth device
or vice versa.
 Check the pairing and connection procedures
in the manual of the other device, etc., and
perform the operation again.
46
The name of the detected device does not
appear.
 Depending on the status of the other device, it
may not be possible to obtain the name.
No ringtone.
 Adjust the volume by rotating the control dial
while receiving a call.
 Depending on the connecting device, the
ringtone may not be sent properly.
– Set "RINGTONE" to "1" (page 23).
 The front speakers are not connected to the
unit.
– Connect the front speakers to the unit. The
ringtone is output only from the front
speakers.
The talker's voice volume is low.
 Adjust the volume level.
The talker's voice cannot be heard.
 The front speakers are not connected to the
unit.
– Connect the front speakers to the unit. The
talker's voice is output only from the front
speakers.
A call partner says that the volume is too low
or high.
 Adjust the volume accordingly using mic gain
adjustment (page 27).
Echo or noise occurs in phone call
conversations.
 Lower the volume.
 Set EC/NC Mode to "EC/NC-1" or "EC/NC-2"
(page 27).
 If the ambient noise other than the phone call
sound is loud, try reducing this noise.
E.g.: If a window is open and road noise, etc., is
loud, shut the window. If an air conditioner is
loud, lower the air conditioner.
The phone is not connected.
 When Bluetooth audio is played, the phone is
not connected even if you press .
– Connect from the phone.