Starting And Operating - HAVER & BOECKER HAVER UWL 400 Notice D'utilisation

10.

Starting and operating

1 LCD-Display
2 - Key to determine the time switch (counting backwards)
MODE – Key for starting and stopping the timer
3
4 + Key to determine the time switch (counting forward)
5 Main switch, Emergency stop switch
10.1 Switch ON the machine with the main switch (5). The LCD-Display indicates 0:00.
10.2 Preset the desired sieving time with the + Key. A short pressing presets the time in 1 minute steps.
When pressing longer than 3 seconds a quick counting forward starts (max. 9 hours and 59 minutes).
10.3 If by mistake the time has been preset too long, the error can be corrected
with the – key.
10.4 Pressing the MODE-key starts the unit. Pressing it twice stops the unit, the remaining short time is
indicated by the display. Pressing the key again, the unit starts again and the timer continues running
with the remaining time.
10.5 An acoustic alarm is activated at the end of sieving. For the next sieving, the time has to be set
again.
Feeding capacity: up to 20 kg depending on the apparent bulk density and maximum
volume of residue after sieving has been completed.
If not used for a certain time, pull out the mains plug. Protect the machine against dust.
© Copyright 2009 by HAVER & BOECKER Page 25/40