Assembly Uwl 400 H - HAVER & BOECKER HAVER UWL 400 Notice D'utilisation

7.2 UWL 400 H
© Copyright 2009 by HAVER & BOECKER
Put the machine on the floor and remove the transport eyelet (1).
Do not use a rubber support!
Connect the guide rods (1) with the enclosed counter sunk screw
sidewise at the frame.
Put on the wooden sieve pan (3), the test sieve set (2) and fill the
sieving material in the upper test sieve.
Please notice item 9, Test sieving according to ISO 2591-1!
Put on the wooden cover (4), fix the clamping tubes (1) at the
appropriate height by using the spring cotters, lay on the terminal
strip(5) and fix it simultaneously with the two nuts (6).
The machine should not be used without test sieves!
Fix the holding device and the separate control gear to the wall.
Connect the mains plug, pay attention to the power supply!
Page 23/40