Application References; Assembly - HAVER & BOECKER W.S. TYLER Ro-Tap RX-29 Notice D'utilisation

2.2 Application references

The machine has been constructed according to the actual technical standards and the
recognized safety specifications. Although, there might be dangers for the user or third
persons or impairments of the machine and other goods.
Only use the machine in perfect technical constitution. Follow the operating instructions
conscious of safety and danger. Repair defects at once by authorized and qualified
persons!
The machine has exclusively been developed for grain sieving to determine particle
distribution. Any other or further application is not as agreed upon. The
manufacturer/supplier will assume no responsibility for damages as a result of improper
use. The risk is on the user's side.
For wet-sieving the RO-TAP needs a special "wet-kit"! Costs and information
about this additional equipment upon request.

3. Assembly

Place the machine on a concrete foundation or a heavy, wooden work bench. The base plate
contains two threaded holes for a fixing with two M 8 bolts (see fig. 2.1).
Do not tighten the bolts too much. The rubber bar at the bottom of the test sieve shaker
avoids that the machine slips away.
To fix the machine on the wooden work bench 2 carriage bolts M 8 x 140 mm with screw nut
and washer can be used.
When installing the machine please take care that it is not accessible from
downside. As the RO-TAP is open at the bottom, there is a risk of injury.
If the machine is installed as described, there is no risk of injury.
© Copyright 2014 by HAVER & BOECKER Page 19/44