Intended Use; Sheet Sander Safety Warnings; Residual Risks - Ryobi One+ R18Ss4 Traduction Des Instructions Originales

Safety, performance, and dependability have been given
top priority in the design of your sheet sander.

INTENDED USE

The sheet sander is intended to be used only by adults who
have read and understood the instructions and warnings in
this manual, and can be considered responsible for their
actions.
wood, plastic or similar materials using the abrasive pads
or sheets provided.
The product should only be used in well ventilated areas.
This product is designed for dry sanding only. Do not use
for wet sanding.
The product is intended for consumer use only. Do not use
the product for any other purpose.
WARNING
Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may result in
Save all warnings and instructions for future reference.

SHEET SANDER SAFETY WARNINGS

Always wear safety goggles and a dust mask.
A suitable breathing respirator must be worn while
sanding lead paint, some woods and metal to avoid
breathing the harmful/toxic dust or air. Contact with
or inhalation of dust produced from these materials can
endanger the health of operator and bystanders.
Do not throw sanding dust on an open fire because
materials in fine particle form may be explosive.
The product is not suitable for wet sanding.
When not in use, all tools should be disconnected from
power source.
sanded as well as the sander. Always empty the dust
collector before taking breaks.
Clamp workpiece with
damage. Do not hold the material you are sanding by
hand.
Do not apply excessive pressure to the product.
Do not use sanding paper larger than needed. Extra
paper extending beyond the sanding pad can also
cause serious lacerations.
Ambient temperature range for tool during operation is
between 0°C and 40°C.
Ambient temperature range for tool storage is between
0°C and 40°C.
The recommended ambient temperature range for the
charging system during charging is between 10°C and
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps
or tape. Do not transport batteries that are cracked or
leaking. Check with the forwarding company for further
advice.
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise and the operator
should pay special attention to avoid the following:
a clamping device.
38°C.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING
damage due to a short circuit, never immerse your
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.
Ambient temperature range for battery during use is
between 0°C and 40°C.
Ambient temperature range for battery storage is
between 0°C and 20°C.

RESIDUAL RISKS

Additional caution must be exercised to prevent
operator's fingers and hands from coming into contact
with the sanding sheet
contact with or inhalation of dust
While using the product, considerable dust and fine
particles will be produced. Use the dust collection
device when operating the product. Wear respiratory
protection masks containing filters appropriate to the
materials being worked. Ensure adequate workplace
ventilation. Do not eat, drink, or smoke in the work area.
risk of explosion
Accumulated fine dust may ignite and cause fire. Keep
the work area clean and free from dust. Dust collection
and vacuum extraction systems should be regularly and
thoroughly cleaned. When sanding metal, hot sparks
may be produced.
noise and vibration
Wear ear protection when operating the product. Do not
operate the product for extended periods of time.
EN
FR
DE
ES
IT
LT
English | 1