benza BZT1000 R3 Mode D'emploi page 58

Note:
1. Press and release the reverse lever 2 ~ 3 times and confirm gear. If it does not operate normally, contact someone qualified
to examine it.
2. When using the power tiller, you must loosen the reverse lever and the reverse must return without hitting the transmission
gear. Pay attention to any abnormal noise as the gear may be damaged.
3. Clutch cable adjustment method The use of the machine will lead to some wear and tear from friction resulting in the clutch
holder which regulates the clutch cable. See chapter 3 for further information.
4. When confirming that the tiller does not return to its normal driving condition, see chapter 4 for correction.
Note:
1. Press and release the reverse lever 2 ~ 3 tines and check the gear. Adjust if it not as required.
2. If repeated adjustments do not solve the problem and you see that the clutch cable is worn, replace it for a new one.
3. Removing the clutch is strictly prohibited as the clutch and other parts may be damaged.
4. Clutch cable adjustment method.
When turning the throttle switch, the engine may increase or decrease its speed.
Note:
1. Repeatedly turning the throttle switch 2 ~ 3 in a petrol plus engine, must loosen and confirm performance.
2. Use screws for connecting the throttle cable and the adjoining levers.
4.6 USING THE HANDLEBAR STRUCTURE AND ADJUSTMENT METHOD
You can adjust the handlebar right, left, up and down according to your height requirements and the specific farming and ploughing
requirements. The method is as follows:
1. At the handlebar, adjust:
· The regulating handle.
· Select the best position of the handle structure for the operating height required.
· Then, loosen the regulating handle, insert the bars into the corresponding hole until the handlebar is properly adjusted.
2. Adjusting the right, left armrest handle.
· Manually hold the level of the regulator handle mentioned on the bars.
· Turn the handlebar structure to the left and to the right again if needed.
· Once released, insert the corresponding handle in the hole and decide if you wish to move the handlebar structure to the left or to
the right.
Note: To ensure that the rotating tines maintain a proper safety distance, please check that the left-right rotating angle of
the handlebar structure is not below 35 degrees.
· You can control the handle bar upwards and downwards using the height handle and the T locking.
I
56
Manual de usuario