Supporting The Connection Direction To Be Used; Things To Bear In Mind Regarding The Micro Power Tiller - Benza Bzt1000 R3 Mode D'emploi

5. Short-distance transportation.
1. Loosen the clutch.
2. With the gear lever in neutral, turn throttle regulator clockwise toward the minimum position. The machine will stop and press the
ON/OFF Switch with your hand.
3. If the engine should need petrol, follow the instructions for a petrol engine when refuelling.(note: the micro power tiller should be
placed on a flat surface)

4.4 SUPPORTING THE CONNECTION DIRECTION TO BE USED.

1. If you need to turn while you till, remove the wheel and the device of the hex tube will rotate with 8*50 of the axis of the fixed
peg and screw to be removed. Once the tiller rotating blade is installed, you must install a safety protection guard for operating
the machine. You can adjust the cutting speed, the height from the ground and the angle to achieve a different harvesting depth.
2. If you need to open a trench, lower the speed, make the trench and adjust the depth and width required for the trench. (Figure 3)
Stretching the width of the ditch: 14 cm x 40 cm. Stretching the width of the ditch: 11 cm x 25 cm.
3. Short-distance transportation. Rated load: 250 kg the calibration of the speed of the petrol engine must be: high speed at 8 km/h
and low speed at around 4.5 km/h.

4.5 THINGS TO BEAR IN MIND REGARDING THE MICRO POWER TILLER.

1. Pay careful attention to the working conditions and environment before using the machine. All parts and connections must be inspec-
ted to check they are in good working conditions. If you should discover something out of the ordinary, stop the machine and inspect.
2. Do not start to work with a cold machine, particularly in the case of new machines or start working with heavy loads.
3. Check that the level of oil in the petrol engine and the transmission. if insufficient, add oil.
4. The use of water to cool down the engine is prohibited.
5. After using the machine, remote the mud, the weed and the lubricating oil from the plough. Keep it clean to prevent it from rusting.
6. Frequently wipe the machine body using a sponge and change oil.
7. Choosing gears You can choose among five gears when operating the power tiller. How to change gears:
1. Turn the throttle switch in the opposite director (left - minimum)
2. Press the clutch.
3. Move the gear mechanism as required for your needs.
4. Loosen the clutch and the power tiller will be ready for operation. Loosen the clutch.
I
54
Manual de usuario