Operation - Benza Bzt1000 R3 Mode D'emploi

3. Air filter. Remove air filter cap and add approximately 0.1 litres of SAE15W-40 oil.
4. On the basis of environment temperature, select the suitable engine oil from the table.
5. Resupply: add -10 # petrol oil into the fuel tank (see instructions for using a petrol engine). Note: Do not exceed the upper limit.
6. Follow the instructions before preparing the engine to begin to work.
4.2 START.
Note: The gear lever must be neutral and your hand ready in the event of an emergency stop.
1. Petrol engine operation instructions must be observed, including the steps before starting the engine.
2. The petrol engine must be idle (1600 +-150 r/min) without load 2 ~ 3 minutes.
3. Make sure that the engine operates properly. Otherwise, stop the machine.

4.3 OPERATION.

Note: before using the machine, the operator needs to familiarise with the operating speed of the tiller.
1. Low speed when operating on slopes.
1. Loosen the clutch with the left hand.
2. Use the right hand to pull from the gear lever to change down. Then, hold the right side of the handle again.
3. Slowly with your left hand press the clutch and you can work now with the power tiller at a lower speed.
4. A power tiller at low speed should be operating at about 4.5 km/h
2. High speed on slopes.
1. Loosen the clutch with the left hand.
2. Use the right hand to pull from the gear lever to change gear. Then, hold the right side of the handle again.
3. Slowly with your left hand press the clutch and you can work now with the power tiller at a higher speed.
4. A power tiller at high speed should be operating at about 8 km/h
3. Reverse on slopes
1. Loosen the clutch with the left hand.
2. Use the right hand to pull the gear lever down and pay attention if in position.
3. Slowly with your left hand press the clutch and then the micro power tiller will reverse.
4. Use the handlebar to turn left or right.
53
I