Assembling And Operating The Power Tiller; Check Oil In The Gearbox - Benza Bzt1000 R3 Mode D'emploi

3. ASSEMBLING AND OPERATING
THE POWER TILLER
3.1. POWER TILLER ASSEMBLY
Before leaving the factory, the main parts of the power tiller have been checked. However, those using the machine in micro cultures
must contact a shop for checking and adjustment so that the power tiller offers an improved performance. Owners must follow the
following step to assemble it:
1. The wheel must be installed in the gearbox, at the hex shaft at both sides of the transmission shaft with locking screws.
2. Place the arm in the body in the position required on the basis of the terrain in relation to the axis and insert the depth regulator at
the basis of the tiller.
3. Armrest handle. Pull from the armrest handle at the upper section of the semicircle with the armrest covered and the screw in relief
as shown on Figure A below.
4. Pull up the armrest by pull from the plastic handle. The armrest may be 360 degrees.
5. Mount the fender on the engine fixed support and the body.
Empty the oil, check that the oil level is normal. Oil SAE15W-40 is recommended for general lubrication and is suitable for a general
environment temperature.

3.2. CHECK OIL IN THE GEARBOX.

I
48
Manual de usuario