The Clutch And Its Adjustment; Adjusting The Throttle Levers - Benza Bzt1000 R3 Mode D'emploi

3.5. THE CLUTCH AND ITS ADJUSTMENT

WARNING
Before using the clutch, slow down the engine. Use the clutch to control engine output. By loosening the clutch level the power input will
result in the engine stopping and the tilling blade will also stop. By pressing the clutch, the power input will result in the engine starting
to till with the rotating blade (figure 8)
Note: If clutch levers are poorly adjusted, this will have consequences for the normal operation of the machine. Begin by confir-
ming that the clutch levers have normal degrees of tension. Normal lever degrees should be between 4 and 8 mm free. Then,
the adjustment of the counter nut must be loosened. Adjust properly after stopping. (FIG 9)
Start the engine when necessary and check the clutch.

3.6. ADJUSTING THE THROTTLE LEVERS.

Reach of normal idle speed: 1600 +-150 RPM; high speed: 3600 r/min. You can use the speed adjustment table.
Speed confirmation and adjustment method
I
50
Manual de usuario
FIGURE 8
FIGURE 9