Publicité
A.
B.
The DT-10in MAX diamond blade saw is a powerful and functional
cutter, suitable for cutting all types of manmade and natural tile.
Its advanced water system eliminates most of the dust particles
produced by the cut.
The machine can make straight cuts, angle cuts, miters, and specialty
cuts such as non-through and L-cuts for electrical boxes or heat
registers with ease. With the power, innovation, and versatility, our
Rubi premium features make this the right tool to handle any tile
cutting application.
Failure to observe all of the warnings and instructions
- 4 -
A. TO MAKE A STRAIGHT CUT
B. TO MAKE AN ANGLE CUT
C. TO MAKE AN L CUT
D. TO MAKE A MITER CUT
E. TO MAKE A PLUNGE CUT
and in a good state of operation.
to checking that blade wrench and adjustment tools are taken away
from the machine before starting it.
cause accidents.
electrical tools in damp or wet places or places that are exposed to the
rain. Keep the work area well lit.
use safety glasses and stay a safe distance from the work area. Visitors
must not come into contact with the tool or extension cable while it is
in operation.
switches or removing the starting keys.
Do a better and safer job by working at
the speed for which it was designed.
Do not force the tool or the
accessory to do work for which it was not designed. Do not use it for
an unintended purpose.
extension cable is in good condition. Only use a cable that is of
A smaller cable will cause a drop in voltage in the line, which will
result in a loss of power and overheating. Table A shows the correct
doubt, use the thickest gauge. The smaller the gauge number, the
thicker the cable.
ties or jewellery. They can become trapped and pull you towards
moving parts. Rubber gloves and non-slip footwear (boots with rubber
soles) are recommended when working in the open air. Also use a
protective cap to contain long hair.
for daily use only have impact-resistant lenses, they are NOT
safety glasses.
Use clips or clamps to hold the work whenever
practical, it is safer than using your hand and frees both hands to
use the tool.
Maintain your posture and balance
at all times.
clean for better and safer performance. Follow the instructions for
lubrication and changing accessories.
All tools should be disconnected when
not in use, before carrying out maintenance or changing accessories,
wheels, bits, blades, etc.
before plugging in any tool.
for the recommended accessories. The use of the wrong accessories
can cause injury.
This can result in serious injury if the
tool tips over or the cutting tool starts up accidentally.
check to determine if a damaged guard or other part will operate
correctly and carry out its intended function. Check the alignment of
the moving parts, connections of the moving parts, as well as for any
its operation. A guard or other part that is damaged must be properly
prevent the risk of personal injury.
cut to the blade or cutter only against the rotation direction of the
blade or cutter.
until it is completely stopped.
Get used
Untidy work areas and benches
Do not use
All visitors must
by using padlocks, master
Ensure that your
Do not wear loose clothing, gloves,
Glasses
Keep tools sharp and
See the operating manual
Before using the tool, carefully
Insert the part to be
Do not leave the tool
Publicité
