Lutron RRL-MWCL-WH Manuel D'instructions page 9

1. Mount the wireless controller using the provided screws.
2. Connect the wires from the LED tape to the output
terminal of the controller ensuring to use the correct
output wiring for the LED tape being used.
3. Connect the wires to the input terminal of the controller.
Note: Only one input and one output cable may be
connected to the terminal block. Additional wires must
be spliced outside of the wireless controller.
4. Install the strain relief and tighten the screws.
Note: The strain relief is reversible. Orientation 
provides the best strain relief for most wire diameters.
For some large wire applications, orientation  may
be needed.
Note: All outside wire diameters must be between
0.10 in to 0.25 in (2.5 mm to 6.4 mm).
Note: When installing strain relief, wires should be
positioned such that they are not pulled tight. Cable
sleeve should be positioned under the strain relief as
well.
5. Install the terminal cover.
®
Lutron Tape Light Solution
Wireless Controller Installation
Tape Style Tape Identification
RGB+TW A B C D Blue
2
3
Orientation 1 Orientation 2

9 Customer Assistance — 1.844.LUTRON1
1 2 3 4
Green Red Brown
Correct
Incorrect

5 6
White Black