Lutron RRL-MWCL-WH Manuel D'instructions page 4

5. Join additional sections of LED tape to the
series (optional).
a. Measure and cut the length of cable needed to
connect the tapes in their installed locations.
b. Insert the end of the LED tape into the connector.
Close the connector using pliers.
IMPORTANT: Align the edge of the connector
with the printed line on the tape. Improper
alignment of the connector may damage the
LED tape.
c. Insert unstripped, Lutron provided, 22 AWG
(0.50 mm ) wires into the wire holes in the connector
2
ensuring to align the wire color to the appropriate
channel on the tape.
Tape Marking Wire Color
Bk Black
W White
B Brown
R Red
G Green
Bu Blue
d. Only 16.4 ft (5 m) of tape may be wired in series for
any run of tape. If more than 16.4 ft (5 m) of tape will
be used (up to the controller's rating) multiple runs of
tape should be wired in parallel.
®
Lutron Tape Light Solution
LED Tape Installation
Controller Terminal
6
5
4
3
2
1
(continued)
Wireless Controller
Wire to LED Tape
Tape
Connector
Connector
5c
•
•
LED Tape
Wire to
•
Tape
Connector
LED Tape
Wire to
Tape
Connector
4
Wire to Wire to LED Tape
Tape Tape
Connector Connector
5b
16.4 ft (5 m)
max per run
Not to exceed
32.8 ft (10 m) max
per controller
16.4 ft (5 m)
max per run
www.lutron.com/support