Lutron RRL-MWCL-WH Manuel D'instructions page 5

WARNING: SHOCK HAZARD. May result in
Serious Injury or Death. Disconnect power
before servicing or installing the unit.
Note: This section is for installation of LU-PH3-B.
For installation of LU-PH3-A, proceed to the next
section.
1. Remove the top cover of the power interface to access
the mounting holes and flying leads.
2. Choose a mounting location. Consider the following
when choosing a mounting location:
a. For cabinet and surface mount use only.
b. Install remotely from controller and tape light.
c. A minimum of 2 in (51 mm) is required between power
interface and any other equipment or surface.
d. Before mounting using the included wood screws, drill
pilot holes into the mounting surface with a drill bit no
larger than 5/64 in (2 mm) in diameter.
e. Leave .25 in (6.35 mm) of each screw protruding from
mounting surface.
f. Align the four keyhole slots on the back of the power
interface over the screws, then slide gently from
the left to the right (Option 1) or from the top to the
bottom (Option 2).
g. Mount the power interface in a position where it
can be easily located and accessed if service or
troubleshooting is necessary.
h. Any other mounting configurations will require
additional mechanical support. Improper installation
may result in hazards to personnel or property.
3. Open the necessary knockouts to pass wires into the
wiring compartment.
®
Lutron Tape Light Solution
Power Interface Installation - LU-PH3-B
2.0 in
(51 mm)
Option 1
Option 2
5 Customer Assistance — 1.844.LUTRON1
4.5 in
(114 mm)
2.
1.