Installation Warnings - Summit Ffbf151W Mode D'emploi

1.2 Installation Warnings

Before using your fridge freezer for the first
time, please consider the following points:
• The operating voltage for your fridge
freezer is 115-127 V at 60Hz.
• The plug must be accessible after
installation.
• Your fridge freezer may emit an odor when
first operated. This is normal, and the odor
will fade as it cools.
• Before connecting your fridge freezer,
ensure that the information on the data
plate (voltage and connected load)
matches the mains electricity supply. If in
doubt, consult a qualified electrician.
• Insert the plug into a socket with an
efficient ground connection. If the socket
has no ground contact or the plug does not
match, we recommend you consult a
qualified electrician for assistance.
• The appliance must be connected
with a properly installed fused socket. The
power supply (AC) and voltage at the
operating point must match with the details
on the name plate of the appliance (the
name plate is located on the inside left of
the appliance).
• We do not accept responsibility for any
damages that occur due to ungrounded
usage.
• Place your fridge freezer where it will not
be exposed to direct sunlight.
• Your fridge freezer must never be used
outdoors or exposed to rain.
• Your appliance must be at least 20 inches
away from stoves, gas ovens and heater
cores, and at least 2 inches away from
electrical ovens.
• If your fridge freezer is placed next to a
deep freezer, there must be at least 1 inch
between them to prevent humidity forming
on the outer surface.
• Do not cover the body or top of fridge
freezer with lace. This will affect the
performance of your fridge freezer.
• Clearance of at least 6 inches is required
at the top of your appliance. Do not place
anything on top of your appliance.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly before use
(see Cleaning and Maintenance).
• Before using your fridge freezer, wipe all
parts with a solution of warm water and a
teaspoon of sodium bicarbonate. Then,
rinse with clean water and dry. Return all
parts to the fridge freezer after cleaning.
• Use the adjustable front legs to make sure
your appliance is level and stable. You can
adjust the legs by turning them in either
direction. This must be done before placing
food in the appliance.
• When the product is operating, the side
panels may become noticeably warm. This
is normal.
• In order for the product to work efficiently,
there must be some gap around it for air
circulation. If you are going to place the
product in a recessed area on the wall,
make sure that the gap should be 4 inches
between top surface and ceiling, 2 inches
between walls and side panels. The
distance between the appliance and back
wall must be a maximum of 3 inches.
EN - 6