Target Laser; Commissioning; System Settings - VOLTCRAFT IR-1600 CAM Notice D'emploi

c) Target laser
The target laser is active during measurement depending on the pre-setting. A warning icon appears in the display
with the laser active. Never look into the laser aperture (12) during measurement.
The target laser is designed as a twin device and marks the
Laser point
IR measuring area

8. COMMISSIONING

• Before working with the meter, you have to insert the enclosed li-ion rechargeable battery.
• Insert the rechargeable battery as described in the chapter "Cleaning and Maintenance" and charge it.
• The IR-thermometer permits individual system settings for measuring that you should perform after initial commis-
sioning.
• Switch on the meter. For this, hold down the button "ESC" (4) for approx. 3 seconds until a beep sounds. Release
the button and the meter will switch on after a brief time. Open the lens protection cover (8).
• Proceed accordingly to switch off.
• After switching on, you are in the main menu "MENU", from where you can select all functions.
a) System settings
To get into the setting mode, push the button "Up" (5) or "Down" (3) in the main menu "MENU" until the field "SET-
TINGS" has a blue background. Then push the button "Enter" (6). Use the buttons "Up" (5) or "Down" (3) to select
the respective function or change the value. Press the button "ESC" (4) to return to the previous menu. The function
with a blue background is saved.
The setting menu can be terminated at any time by pushing the button "ESC" (4). The function with a blue
background is saved.
36
Midpoint
Object area
inner, approximate edge area of the measured area
(approx. 90%).
When both laser points meet, the smallest measuring
area has been reached. It is 18 mm in diameter.
For large distances, the two laser points move apart
according to the measuring area.