Publicité
Les langues disponibles
Les langues disponibles
No.
Malfunction
The robot returns to the
6
Station before it has finished
cleaning�
7
The robot is unable to charge�
The robot is very loud during
8
cleaning�
DEEBOT gets stuck while
9
working and stops�
During cleaning, the robot
may encounter issues like
a disorderly route, biased
movement, repeated cleaning
over the same spots, and
missing small areas� (If there
is a large area that has not
10
been cleaned temporarily,
DEEBOT will automatically
clean the missed area�
Sometimes DEEBOT will
re-enter a cleaned room,
which may not be a repeated
cleaning, but DEEBOT finding
any missed area�)
Possible Cause
The room is so large that the robot needs to return to recharge�
In highly complex home layouts, cleaning efficiency may
decrease, possibly resulting in incomplete cleaning�
DEEBOT is not switched ON�
The robot's charging contacts are not fully in contact with the
Station's�
The Station is not connected to power supply�
The Base of the Station is not installed properly�
The Roller Brush/Side Brush is tangled, or the Dust Bin/Filter is
blocked�
The robot is in Strong Mode�
DEEBOT is tangled with objects on the floor (electrical wires,
curtains, carpet fringing, etc�)�
The robot might be stuck under furniture with an entrance of
similar height�
DEEBOT is stuck in a narrow area�
Objects such as wires and slippers placed on the ground block
DEEBOT�
The Driving Wheels may slip on the ground when DEEBOT climbs
steps, thresholds, and door bars, which can affect its judgement
of the entire home environment�
On freshly waxed or polished floors, as well as smooth tiles, there
may be less friction between the Driving Wheels and the floor�
Due to variations in home layouts, some areas cannot be entered
by the robot�
Solution
Please enable Auto Resume� For more details, please follow the
App instructions�
Simplify your home layout�
Switch ON DEEBOT�
Make sure that the robot's Charging Contacts have connected to
the Station's Charging Contacts and
DEEBOT's and OMNI Station's Charging Contacts are dirty� Please
clean these parts according to the instructions in the
Maintenance]
section�
Make sure the OMNI Station is connected to power supply�
Refer to the
[Quick Start]
section for correct installation�
It is recommended to clean the Roller Brush, Side Brush, Dust Bin,
Filter, etc� regularly�
Switch to Standard Mode�
The robot will try various ways to free itself� If its attempts fail,
manually remove the obstacles and restart�
Please raise the furniture, set a physical barrier, or set a Virtual
Boundary via the ECOVACS HOME App�
Tidy up your home, set a physical barrier, or set a Virtual Boundary
via the ECOVACS HOME App�
Before cleaning, please tidy up scattered wires, slippers, and other
objects on the ground as possibly can� If there is any area missed
during cleaning, the robot will correct it automatically� Please refrain
from interfering (such as moving the robot or blocking its route)�
It is recommended to close the door of the affected area and clean
it separately� After cleaning, the robot will return to its starting
location�
Please wait for the wax to dry before cleaning�
Tidy up your home to ensure that the robot can enter the areas to
be cleaned�
flashes� Check whether
[Regular
25 EN
Publicité
