Display; Controls - Carson 501000 Mode D'emploi

a)

Display

The most important information on the current settings is shown
on the LC display.
Timer:
Shows the time since the transmitter was last switched on.
MODEL:
(A, V, H, C, C1)
The aircraft model preset is indicated.
CH:
Indication of the NOR (normal) or REV (reverse) position for the
function channels
LOCK:
This is displayed when the rotary controllers or the MODEL
pushbutton are locked.
V:
Voltage indication for the rechargeable batteries for the trans-
mitter
b)

Controls

Function channels
A function channel stands for the function assigned to a remote
control lever or other control, such as gas/pitch, aileron, rudder,
etc. Under some circumstances, such functions may be perfor-
med by multiple servos simultaneously.
Depending on the aircraft model (MODEL A, V, H, C or C1), the
same function channel may have different functions/effects on a
particular model.
By contrast, the direct assignment of a channel on a receiver to
an individual servo (and thus the effect of that individual servo
on the model) is called a servo channel.
Undervoltage indicator (10)
In addition to the digital voltage indication on the display, the
transmitter also has a red LED that starts blinking when voltage
of 8.5 V is fallen short of. So as not to lose control of the model,
immediately end the flight operation and either charge or replace
the batteries with fully charged ones.
WARNING! Only rechargeable batteries may be used.
If the voltage drops below 7.6 V, the LC display goes out, and
the LED continues to blink.
Now at the latest you must land the model and replace the bat-
teries.
Toggle Switch Channel 5 (5)
The left toggle switch is assigned to Function Channel and Servo
Channel 5 and has purely switching functions.
This can be used for any supplementary function desired, such
as retracting and lowering retractable landing gear with model
planes or switching a gyro from normal mode into head-lock
mode.
This Channel 5 does not have a reverse switch.
8
CARSON 6 Channel Transmitter 501000
Toggle switch, dual-rate (7)
The right toggle switch in the front simultaneously has an effect
on Function Channels 1, 2 and 4.
As a result, the effect of Functions 1,2 and 4 on the model are
reduced from 100% (Position „0") to 70% (Position „1"). This
allows more delicate control of the model, because the maxi-
mum mechanical lever travel remains available for the control
system.
The dual-rate adjustment also has an effect on the influence
exerted by the trim controls.
Trim controls for Function Channels 1, 2, 3 and 4 (13) - (16)
The trim control of a function channel shifts the mid-position of
all the servos that are responsible for performing the function
assigned. This trimming is carried out purely mechanically. If
dual-rate is switched on after the model is trimmed, the degree
of trimming is also reduced to 70%.
Connector socket for flight simulator (23)
The remote control transmitter can also be used to control PC
games or for flight training with a flight simulation program. The
control system data is transmitted via a connection cable from
your transmitter directly to the PC.
This way valuable experience can be gained for real flights,
while going easy on your equipment.
Lock (19)
After making the basic settings for the transmitter, the slide
switch can be used to secure the model selection (MODEL push-
button) and the two rotary controllers against any unintended
switching. A pointed object (such as a small screwdriver, pin,
etc) is required to do the switching. This ensures that the locking
cannot be accidently undone during flight operation.