Changing The Crystal; Maintenance And Care - Carson 501000 Mode D'emploi

e) Model C1
Helicopter model, CCPM
Same functions and allocation as „Model C".
Select the „Model C1" setting if the head servo (pitch) is at the rear, when looking toward
the direction of flight.

Changing the crystal

In order to avoid a double assignment of a channel it may
be necessary to change the crystals on your remote control
system.
For reasons of operational safety, you should only use cry-
stals that are explicitly recommended for the use in your
remote control system by the manufacturer.
To change the crystal, proceed as follows:
● With the transmitter turned off, pull the holder for the trans-
mitter crystal (1) on the back of the transmitter crystal out of
the housing.
● Take the transmitter crystal out of its plastic holder.
● Insert a transmitter crystal with a different channel in the
same frequency band. Please make sure that you place the
correct crystal in the holder. Transmitter crystals are normally
marked with the letter T or TX (T = "transmitter").
●
Put the crystal holder (1) back into the transmitter.
● Switch the receiver system off and remove the crystal (2)
from the plug-in socket in the receiver.
The suitable crystal for the receiver has to be marked with the
same channel number as the transmitter crystal. In addition it is
marked with the code R or RX (R = receiver).
● Insert the receiver crystal with the suitable frequency for the
transmitter into the receiver.
● Switch on the transmitter and afterwards the receiver and
check the functioning of the system.

Maintenance and care

Clean the exterior of the remote control only with a clean, soft, dry cloth. Never use aggressive cleansing agents or chemical solutions,
because they might damage the surface of the housing.
Remove dust with a soft, clean brush.
CARSON 6 Channel Transmitter 501000
13