Model H; Model C1 - Carson 501000 Mode D'emploi

c)

Model H

Helicopter model, mechanical mixer
Remote control lever, left
Remote control lever, right
Reverse Switches
Rotary Controllers 1 & 2
Rotary Controller 1
Rotary Controller 2
Toggle Switch 1
Toggle Switch 2 (3D mode) The gas servo (3) goes to full speed at both full deflections of the remote control lever.
WARNING! Only near the mid-position of the gas/pitch lever should you switch over into the 3D mode. When changing out
of the idle running position, the motor starts running too fast.
d) Model C
Helicopter model, CCPM (collective cyclic pitch mix)
The transmitter's 120° CCPM mixer simultaneously controls in proportionate fashion the three servos staggered by 120° acting direct-
ly upon the swash plate, doing so for roll and pitch functions. Select the „Model C" setting if the head servo (pitch) is at the front when
looking toward the direction of flight.
Remote control lever, left
Remote control lever, right
Toggle Switch 1
Reverse Switch 1
Reverse Switch 2
Reverse Switch 3
Reverse Switch 4
Reverse Switch 6
Rotary Controllers 1 & 2
Rotary Controller 1
Rotary Controller 2
Toggle Switch 1
Toggle Switch 2 (3D mode) The gas servo (3) goes to full speed at both full deflections of the remote control lever.
WARNING! Only near the mid-position of the gas/pitch lever should you switch over into the 3D mode. When changing out
of the idle running position, the motor starts running too fast.
12
forward/backward Servo Channels 3 & 6
Servo channel 3 (gas)
from idle running to full speed
right/left Servo Channel 4
forward/backward Servo Channel 2
right/left Servo Channel 1
1, 2, 4 & 6 All functions
3 Idle running position, top/bottom
Adjusting the pitch curve. Pitch travel is reduced on the
remote control lever so as to also allow full servo
travels with the trimming on Rotary Controller 1.
Pitch trimming of the Helicopter/position of the control lever around the mid-position during hover flight
of the Helicopter (which shifts the zero crossing of the pitch curve)
Influence of the gas/pitch lever on the pitch function (servo channel 6), (which changes the inclination
of the pitch curve).
Recommended for gyro: Norm/head-lock switching
Mid-position: half speed (no idle running position)
Large servo travel for pitch: The entire pitch travel is available directly on the control lever so as to
enable more extreme flight manoeuvres.
Rotary Controllers 1 & 2: No function
forward/backward Servo Channel 3
Servo Channels 1 & 2 & 6
right/left Servo Channel 4
forward/backward Servo Channels 1 & 2 & 6
right/left Servo Channels 1 & 6
Recommended for gyro: Norm/head-lock switching
Roll
Pitch
Gas (idle running position, top/bottom)
Tail
Pitch
Adjusting the pitch curve. Pitch travel is reduced on the
remote control lever so as to also allow full servo
travels with the trimming on Rotary Controller 1.
Pitch trimming of the Helicopter/position of the control
lever for hover flight (which shifts the zero crossing of the pitch curve)
Influence of the gas/pitch lever on the pitch function (servo channel 6), (which changes the inclination
of the pitch curve).
Recommended for gyro: Norm/head-lock switching
Mid-position: half speed (no idle running position)
Large pitch travel: The entire pitch travel is available directly on the control lever so as to enable more
extreme flight manoeuvres.
Rotary Controllers 1 & 2: No function
CARSON 6 Channel Transmitter 501000
Gas/Pitch
Tail
Pitch
Roll
Gas
Pitch
Tail
Pitch
Roll