Model-Specific Functions; Model A; Model - Carson 501000 Mode D'emploi

Installing the servos
The installation of a servo is always dependent on the particular
model used. For specific information, refer to the design docu-
ments of the model. However, generally you should try to fasten
the servos with screws in such a way that vibrations are minimi-
sed. For this purpose, servos are typically supplied with rubber
bushings with metal sleeves.

Model-specific Functions

a)

Model A

Model plane with aileron
Remote control lever, left
Remote control lever, right
Reverse switch
Rotary Controller 1
Toggle Switch 2:
Rotary Controller 2
Reverse Switch 6
b) Model V
Model plane with V-tail
Remote control lever, left
Remote control lever, right
Reverse Switches
Rotary Controller 1
Rotary Controller 2
Toggle Switch 1
Toggle Switch 2
No „Flaperon" (flap + aileron) / fowler flap adjustment is possible, because the
aileron is only triggered by one servo.
Delta-winged aircraft
Remote control lever, left
Remote control lever, right
CARSON 6 Channel Transmitter 501000
forward/backward Servo Channel 3
right/left Servo Channel 4
forward/backward Servo Channel 2
right/left Servo Channel 1 & 6
1 Both ailerons
2, 3, 4 Elevator servo / gas servo / rudder servo
Servo travel adjustment for Function Channels 1, 2 and 4 Reduction to 1/6 of the maximum control
travel
„Flaperon" (flap + aileron) / fowler flap adjustment
The mid-position of the aileron servo adjusts in the oppo-
site direction, such that the ailerons no longer meet flush
with the surface, but rather, both deflected in the same
direction, simulate a fowler flap (flaperon). The actual aile-
ron function is maintained when this is done.
Deflecting the ailerons (fowler flaps) from the mid-positi-
on.
Fowler flaps upward or downward, as desired
forward/backward Servo Channel 3
right/left Servo Channel 4
forward/backward Servo Channels 1 & 2
right/left Servo Channels 1 & 2
1, 2, 3 & 4
Servo travel adjustment, Channels 1 & 2
Reduction to 1/6 of the maximum control travel
Servo travel adjustment, Servo Channel 4
Free switch (Receiver Channel 5)
Free switch (Receiver Channel 6)
forward/backward Servo Channel 3
right/left Servo Channel 4
forward/backward Servo Channels 1 & 2
right/left Servo Channels 1 & 2
Checking the control functions
Connect the servos and/or speed controllers and the power
supply to the receiver.
Switch on the transmitter and then the receiver. If you have
connected everything correctly, all the servos should respond
correctly.
If one or more functions should not respond correctly, then you
can correct the relevant adjustments.
Gas
Rudder
Elevator
Aileron
Gas
Aileron
Elevators
moving in same direction
Rudders
moving in opposite directions
Gas
Rudder
Elevators
moving in same direction
Ailerons
moving in opposite directions
11