Switching The Device On - Olympia PS 36 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
4
Starting Up
1. Remove the device carefully from the packaging.
Attention:
The underside of the cutting mechanism attachment has sharp edges. Risk
of injury!
2. Replace the shredder attachment on the waste bin supplied.
Note:
The shredder attachment must not wobble!
3. Set the waste bin and shredder attachment on an even surface.
4. Position the device near a power socket. However, do not position the waste bin and
shredder attachment near a source of heat or in the vicinity of water.
5. Connect the power plug to a power socket.
Note:
Pay attention that the power cable is laid so that people or pets do not walk
over it or that other objects can be set down on it. Pay attention to the in-
formation regarding power supply on the rear side of the device for the
necessary precautions.
Safety information:
5
Operation
Note:
The recommended capacities stipulated in Chapter "Technical Data" must
not be exceeded, otherwise paper will jam! Do not forget that the thickness
of the paper increases when folded, as a result of which the recommended
sheet capacity can be exceeded. Also reduce the quantity of paper when
shredding coarse paper.
5.1
Sliding switch
The sliding switch is used to control the cutting mechanism in the paper shredder. The
sliding switch can be set to three positions:
Position Rev: Continuous reverse running.
Position Off: Paper shredder is switched off.
Position Auto: When set to Auto, the shredding operation of the cutting mechanism
is started automatically as soon as paper is fed into the paper infeed. The device
switches to forward drive and draws the paper in. On completion of the shredding
operation, the device continues running for approx. 2 to 4 seconds and then switches
off automatically.
5.2

Switching the device on

1. Connect the power plug to a power socket.
2. Set the sliding switch to Auto.
For reasons of safety, the power socket to which the shredder
power plug is connected must be near to the device and freely
accessible so that the power supply can be disconnected
quickly in an emergency!
17

Publicité

Table des Matières
loading

Table des Matières