Sonoro PRESTIGE SO-330 Mode D'emploi page 77

Connecting with a
paired Bluetooth
headphone,
To disconnect a paired
Bluetooth headphone,
© sonoro audio GmbH 2021
The small Bluetooth headphone icon
and indicating that PRESTIGE is in pairing mode. The
Bluetooth headphone icon
the pairing is completed. The paired Bluetooth
headphone device name is temporarily shown in the
display.
Note: Make sure that your Bluetooth headphone is
already in discovery mode and ready for pairing.
For detail please refer to your Bluetooth device
instruction manual.
In all operation modes except the Bluetooth mode,
press and hold key on remote control. Or, press
SETUP once, then
knob) to select [Bluetooth headphone], then select
[Bluetooth pairing], then [Paired devices], and then
press OK to confirm. Your paired Bluetooth device
names are shown in the display. Select your device
and press OK to confirm.
The small Bluetooth headphone icon
and indicates that PRESTIGE is in pairing mode. The
Bluetooth headphone icon
the pairing is completed. The paired Bluetooth
headphone device name is temporarily shown in the
display.
Note: Make sure that your Bluetooth headphone is
already in pairing mode, for detail please refers to
your Bluetooth device instruction manual.
Press SETUP once, then
navigation knob) to select [Bluetooth headphone],
then select [Bluetooth disconnect] and then press
OK to confirm.
stops blinking when
▬
or (or rotate the navigation
+
stops blinking when
▬
or (or rotate the
+
is blinking
GB
is blinking
77