Performing Initial Setup - Sonoro PRESTIGE SO-330 Mode D'emploi

3.4

Performing initial setup

When PRESTIGE is powered on for the first time, the "Language' (to be used in
the display) selection appears on the display. Then, the "Setup wizard" appears
on the display. Follow the instructions below to configure some basic settings.
1. When the "Setup Wizard" is displayed, press
rotate the navigation knob) to select "YES" and then press OK to start the
setup.
2. You are then prompted to select:
•
Time format (12 or 24-hour),
•
Source of auto update (Update from Radio, Internet or no update).
Depending on the selection you have made, follow the instructions on the
display to further set up date and time, time zone, daylight saving or wireless
network. Rotate the navigation knob on PRESTIGE or press the navigation
buttons on the remote control to make selections and then press OK to
confirm (see chapter "Using the menus").
When update from Internet is selected, Wi-Fi connection must be first
established. When entering the key of your wireless network, rotate the
navigation knob on PRESTIGE or press the navigation buttons on the remote
control to select a character and then press OK to confirm. To delete the last
entry, select [BKSP]. To cancel entering the key, select [CANCEL]. To confirm
the entered key, select [OK].
When "Setup wizard completed" appears, press OK to exit the
3.
setting.
74
▬
or on the remote control (or
+
© sonoro audio GmbH 2021