Installation Instructions And Door Reversibility - De Dietrich DRL774LJ Guide D'utilisation

INSTALLATION INSTRUCTIONS AND DOOR
REVERSIBILITY
Installation instructions
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Unscrew two screws at the top surface. (fig.D)
3. Peel the double sided tape at the bottom surface of trim flap
flap into slot and screw by 2 screws(6) to left / right side. (fig.E)
(1)
IMPORTANT NOTICE: Do not screw any screw to the middle.
4. Pass the power cord through ventilation shaft and position it so that the
appliance could be easily plugged in once it has been installed. (fig.B - fig.C)
5. Take out the trim gasket
stick it on reverse side of the door hinges of the appliance. (fig.E - fig.F)
6. Raise the appliance and slide into the kitchen unit.
7. Push the appliance to the reverse side of the door hinges providing that the
trim gasket
2
8. Align the front feet with front surface of the kitchen unit. (fig.G)
9. Screw the front feet by using screws
10. Screw trim flap
11. Screw guides
12. Lean appliance door to unit door as it is opened at right angle.
13. Slide rails into guides
4
14. Screw the rails
15. Set 1~2 mm gap on handle side between unit itself and unit door by adjusting
guides
. That is vital for appliance performance. (fig.I)
3
located on the side panel of the appliance and
4
covers the space between the appliance and the kitchen unit.
to kitchen unit using screws
1
to appliance door with screws
3
aligning the groove. (fig.I)
3
to the unit door with screws
4
. (fig.G)
5
. (fig.H)
5
. (fig.I)
6
. (fig.I)
5
EN-43
. Insert trim
(1)