DK2 POWER OPV425 Mode D'emploi page 18

OPERATION
STARTING THE ENGINE
STARTING THE ENGINE
1. Open the fuel valve by moving the lever to the right (a1).
NOTE: If the engine is cold, move the choke lever to the CLOSE position (b1). If the engine is
hot, set the choke to the OPEN position (b2).
2. Turn the engine switch to the ON position (e1).
3. Open the throttle by moving it slightly to the left (d1).
Pull the starter rope (c).
4.
NOTE: If the oil level in the engine is low, the engine will not start. If it doesn't start, add oil to
the engine. Some engines are equipped with an oil alert light that will come on while pulling
the starter rope.
Open the choke as the engine warms (b2).
5.
6. Open the throttle fully to operate.
18 | OPV425 man.