Installation Requirements; Tools And Parts; Location Requirements; Minimum Dimensions - KitchenAid W11103357B Instructions D'installation

Masquer les pouces

Table des Matières

Les langues disponibles

These installation instructions cover different models. The

appearance of your particular model may differ slightly from the

illustrations in these Installation Instructions.

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Tape measure

■

#2 Phillips screwdriver

■

Drill

■

Parts supplied

The Microwave Drawer is preassembled.

1" (2.5 cm) mounting screws (4)

■

Verification needed

Installer must confirm presence of anti tip block. Refer to the

■

anti-tip block section in the manual.

Check local codes. Check existing electrical supply. See

■

"Electrical Requirements".

It is required that all electrical connections be made by a

■

licensed, qualified electrical installer.

Location Requirements

This product is suitable for use below electric or gas built-in

ovens. This product is not suitable for use below cooktops.

The Microwave Drawer may be located in a cabinet or below

the counter, and/or below a built-in oven. Check the opening

where the Microwave Drawer will be installed. The location must

provide:

IMPORTANT: Observe all governing codes and ordinances.

Wood cabinetry.

■

Cutout opening that is plumb and square. See "Minimum

■

Cutout Dimensions" in the "Minimum Dimensions" section.

Cutout floor that is solid, level, and flush with bottom of

■

cabinet cutout.

Support for weight of at least 100 lbs (45.4 kg), which

■

includes Microwave Drawer and items placed inside.

Grounded electrical outlet. See the "Electrical Requirements"

■

section.

Minimum installation clearances for installation location. See

■

the "Minimum Dimensions" section.

Complete enclosure around the recessed portion of the

■

Microwave Drawer.