Location Requirements - Jenn-Air JVR0430HS Instructions D'installation Et Guide D'utilisation Et D'entretien

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician to install the range hood. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial/rating plate. The model/serial/
rating plate is located behind the left filter on the rear wall of
the vent hood.
Canopy hood location should be away from strong draft
areas, such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance.
The canopy hood mounting location must be capable
of supporting 100 lbs (45.4 kg).
This range hood is recommended for use with cooktops
with a maximum total rating of 68,000 BTUs or less.
Grounded electrical outlet is required. See the "Electrical
Requirements" section.
All openings in ceiling and wall where canopy hood will be
installed must be sealed.
For Mobile Home Installations:
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities
and Setups) ANSI A225.1/NFPA 501A, or latest edition, or
with local codes.
Product Dimensions
A
B
C
A. 12 / " (32.0 cm)
19
32
B. 12 / " (32.6 cm)
27
32
C. For 30" (76.2 cm) models,
29 / " (76.0 cm)
29
32
For 36" (91.4 cm) models,
35 / " (91.2 cm)
29
32
D. For 30" (76.2 cm) models,
17 / " (45.6 cm)
61
64
For 36" (91.4 cm) models,
17 / " (45.6 cm)
61
64
6
G
F
E
D
E. 2 / " (6.1 cm)
13
32
F. 24 / " (61.0 cm)
1
32
G. 38 / " (98.0 cm) min.
19
32
50 / " (128.0 cm) max.
13
32
Cabinet Dimensions
11 / " (30.0 cm) max.
13
16
Side
cabinet
"X"
bottom of
canopy
to cooking
surface
*For non-vented (recirculating) installations
IMPORTANT:
Minimum distance "X": 24" (61.0 cm) from electric
cooking surface.
Minimum distance "X": 30" (76.2 cm) from gas
cooking surface.
Suggested maximum distance "X": 36" (91.4 cm)
NOTE: For best performance of the Auto Sense feature, the
range hood should be installed at 24" (61.0 cm) from an electric
cooking surface and 30" (76.2 cm) from a gas cooking surface.
The chimneys can be adjusted for different ceiling heights.
See the following chart.
Non-Vented Installations (Recirculation Only)
Min. ceiling height
Electric cooking 7' 10" (2.39 m)
surface
Gas cooking 8' 4" (2.54 m)
surface
*NOTE: The range hood chimneys are adjustable and designed
to meet varying ceiling or soffit heights depending on the
distance "X" between the bottom of the range hood and
the cooking surface. For higher ceilings from 10' 4" to 12'
(3.24 m to 3.66 m), a Stainless Steel Chimney Extension Kit
Part Number W10646864 is available from your dealer or an
authorized parts distributor. The chimney extension replaces
the upper chimney shipped with the range hood.
11 / " (30.0 cm) 13
16
19 / " (50.0 cm)
11
16
Side
cabinet
30" (76.2 cm)
or
36" (91.4 cm)
Centerline
Cooking surface
Max. ceiling height
10' 4" (3.24 m)
10' 4" (3.24 m)