Jenn-Air JVR0430HS Instructions D'installation Et Guide D'utilisation Et D'entretien page 14

3.
Install charcoal filter
Slide the charcoal filter into place on the bracket as shown.
■
Secure the charcoal filter in three locations with the clamps
■
provided as shown.
4.
Install the chimney cover
Slide the chimney cover into the slot over the canopy and
■
adjust the height of the chimney as needed.
Chimney height:
■
Minimum: 38 / " (98.0 cm)
37
64
Maximum: 50 / " (127.9 cm)
23
64
Tip: Ensure the hood is connected electrically and working
before assembling the chimney cover.
14
5.
Secure the chimney to bracket
min 980 mm
max 1279 mm
Fasten the top of the chimney to the filter bracket with the
■
screws provided.
6.
Reinstall grease filter
Install the grease filter back into position.
■