KERN and SOHN ALJ Mode D'emploi page 137

 The display for weight determination of the "sample in air" appears.
 Confirm by pressing the PRINT button.
 If necessary, tare and put the sample.
 Wait until the weight display of the weighing balance has become stable and
then press the PRINT button. „WEI AIR" appears flashing.
 The display for weight determination of the "sample in the measuring fluid"
appears.
 Acknowledge using PRINT button
 Immerse sample holder and tare by pressing the TARE-key
 Place sample and immerse it
Make sure that the sample holder does not touch the beaker.
 Wait until the weight display of the weighing balance has become stable and
then press the PRINT button. „WEI LIQ" appears flashing.
 The density of the sample is shown
Return to weighing mode
 Press the ON/OFF key
 or use the MENU button to start a new measuring cycle.
If at the density determination errors have appeared, „d-----„ is displayed.
ALJ/ALS/PLJ/PLS-BA-e-1640 59