CMi C-BH-800/2,5 Notice Originale page 22

GB
• When working, hold the power tool firmly with
both hands and ensure you have a stable foot-
ing. The power tool can be guided in a safer fash-
ion when you use two hands.
• Always comply with the all applicable domes-
tic and international safety, health, and work-
ing regulations. Inform yourself before you start
work about the regulations that apply at the site of
the device.
• Remember that moving parts may also be located
behind ventilation and venting slots.
• Symbols affixed to your tools may not be removed
or covered. Information on the device that is no
longer legible must be replaced immediately.
Before putting the unit into operation, read
and observe the instructions for use.
Risks caused by vibrations
CAUTION! Risk of injury due to vibra-
tions! Vibrations may, in particular for
persons with circulation problems, cause
damage to blood vessels and/or nerves.
If you notice any of the following symp-
toms, stop working immediately and con-
sult a doctor. Numbness of body parts,
loss of sense of feeling, itching, pins and
needles, pain, changes in skin colour.
The vibration values specified in the technical data
represent the main uses of the device. The actual
existing vibrations during use may deviate from these
as a result of the following factors:
• Incorrect use of the product;
• Unsuitable tools inserted;
• Unsuitable material;
• Insufficient maintenance.
You can reduce the risks considerably by following
the tips below:
– Maintain the device in accordance with the
instructions in the operating instructions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and your
hands, in particular, are kept warm.
– Take regular breaks and move your hands at the
same time to promote circulation.
Remaining risks
There will still be residual risks even when the device
is used according to the instructions and under obser-
vation of all of the safety notes in this set of operating
instructions:
• Touching the tool in the uncovered section.
• Reaching into the operating tool.
• Kickback from work pieces and work piece parts.
Personal protective clothing
Wear goggles and ear defenders when us-
ing the device.
When working with tools that cause consid-
erable dust, wear a dust protection mask.
22
Do not wear protective gloves when work-
ing with the device.
Wear tight fitting clothes when working with
the device.
If you have long hair, cover or wear a hair
net.
Your device at a glance
Note: The actual appearance of your
product may differ from the illustrations.
► P. 3, fig. 1
1. Tool receiving socket
2. Depth stop
3. Lock button for depth stop
4. Locking button
5. On/Off switch
6. Rotation direction switch
7. Mode changing switch
8. Lock button for mode changing switch
9. Additional handle
10. Holder for the depth stop
Scope of delivery
• Chipping hammer
• Additional handle
• Depth stop
• Drill (3×)
• Chasing bit (2×)
• Drill chuck
• Operating instructions
Assembly
Mounting the depth stop
– Press locking switch (3) and keep it pressed.
– Insert the depth stop into the holder (10).
– Set the depth stop to the required depth.
– Release locking switch (3) again.
Operation
Removing a tool
CAUTION! Risk of injury! Shortly after
being used, the tool may be very hot. Risk
of burning! Allow a hot tool to cool down.
Never clean a hot tool with flammable liq-
uids.
► P. 3, fig. 2
– Pull the tool holder (1) back.
– Remove the tool.